Welcome, Guest

Welcome to MMS Forum!

We encourage new members to post a short introduction of themselves in this forum category. Get to know your fellow board members and their interests and skills. Please come and participate in educating people about the healing miracle that is MMS, and join the movement to make it available to the World!

Page:
1
2

TOPIC:

Precipitate formation in MMSI solutioin 01 Jun 2012 09:57 #18091

mouli
Topic Author
Offline
New Member
Posts: 16
Thank you received: 6

Hai All

I have been using MMSI for the past one year. Recently, I can see some sort of floating precipitates in the MMS I solution. As I know, it is only 28% sodium chlorite of distilled water. Is there any chance the chemical can precipitate? I normally store at dark, room temperature.

Or I certainly think its not, but is there any possibility for contamination (any growth of microbes) of MMS I solution?

Your comments are highly valued.
Thank you.

The following user(s) said Thank You: secretariat1844

Please Log in or Create an account to join the conversation.

Re: Precipitate formation in MMSI solutioin 01 Jun 2012 15:31 #18099

mouli Topic Author Offline New Member Posts: 16 Thank you received: 6	Thank you for your quick reply Mr.Steve. I have a flip top dropper - plastic bottle (dark green color). There is no seal or liner in bottle's lid but no leaking issue from this lid. If it is flakes of sodium chlorite, how can i dissolve it again? change of bottle or filtering out, would help? The following user(s) said Thank You: secretariat1844
	Please Log in or Create an account to join the conversation.

Re: Precipitate formation in MMSI solutioin 05 Jun 2012 14:09 #18291

mouli Topic Author Offline New Member Posts: 16 Thank you received: 6	Hai all could someone please give me a solution to this problem?! your help is much appreciated. thank you.
	Please Log in or Create an account to join the conversation.

Re: Precipitate formation in MMSI solutioin 05 Jun 2012 16:37 #18295

pam
Offline
Platinum Boarder
Posts: 4593
Thank you received: 3702

I'm guessing Steve was asking the question because if there was a liner, it might be part of the problem. since you have no liner, it won't be.

You can empty out your MMS into a glass or ceramic cooking pot, and apply a small amount of heat to it. Stir with a plastic or wooden spoon. Everything must be VERY clean, or you will activate the MMS - (It's a mistake I've made) All the flakes will go back into solution. ONce cooled, funnel it back into the holding bottle.

Pam

The following user(s) said Thank You: secretariat1844, mouli

Please Log in or Create an account to join the conversation.

Re: Precipitate formation in MMSI solutioin 05 Jun 2012 16:55 #18296

Whimzy Offline Junior Member Posts: 21 Thank you received: 3	i have same problem.. i just saw some little flakes wirling in there and i just bought this bottle one or two weeks ago is it ok to use it just like that or do need to dissolve them again? how come that there are flakes in there already btw? thank you. The following user(s) said Thank You: secretariat1844
	Please Log in or Create an account to join the conversation.

Re: Precipitate formation in MMSI solutioin 08 Jun 2012 02:03 #18411

mouli
Topic Author
Offline
New Member
Posts: 16
Thank you received: 6

Thanks, Madam. PAM for your reply.

Well, Iam not sure whether I can do your suggested procedure carefully. is there any other ways?
If I keep under the sunlight for some time, would it help to dissolve?

Just wonder, How would I avoid this problem in future? currently, i just store at dark, room temperature.

Your response is highly appreciated.
Thank you.

The following user(s) said Thank You: secretariat1844

Please Log in or Create an account to join the conversation.

Re: Precipitate formation in MMSI solutioin 08 Jun 2012 02:29 #18414

pam Offline Platinum Boarder Posts: 4593 Thank you received: 3702	Sunlight will cause the MMS to become weaker. It is affected by UV rays. Another option would be to put the bottle into a little water on the stove and heat it slowly. You just want to get the solution warm so that the precipitate formation dissolves. The following user(s) said Thank You: secretariat1844, mouli
	Please Log in or Create an account to join the conversation.

Re: Precipitate formation in MMSI solutioin 08 Jun 2012 03:58 #18420

mouli Topic Author Offline New Member Posts: 16 Thank you received: 6	Thanks again Madam. PAM. I'll try it. The following user(s) said Thank You: pam, secretariat1844
	Please Log in or Create an account to join the conversation.

Re: Precipitate formation in MMSI solutioin 25 Jun 2012 01:58 #19173

mouli
Topic Author
Offline
New Member
Posts: 16
Thank you received: 6

As Mr. Steve mentioned, the flakes appearance were because of bottle's liner. Regardless of that, I transferred the mms solution to a clean beaker and did mild heating for a while, then flakes disappeared. but it reappeared again upon cooling.

So, I used a 0.2 micrometer membrane filter to remove the flakes. The solution is very clear now.

To Mr. Steve and Madam. PAM

Is my procedure is okay? The mms solution is light green in color through out the operation. I suppose, if there was any reaction with anything, it would have changed to yellow (if iam not mistaken). Is there a possibility for sodium chlorite to react with membrane filter?

Please advise.
Can I continue to consume the MMS solution?

Your suggestions are highly appreciated.
Looking forward to your reply.

The following user(s) said Thank You: secretariat1844

Please Log in or Create an account to join the conversation.

Last edit: by mouli. Reason: type error

Page:
1
2

Forum

Index

Introduce Yourself

Precipitate formation in MMSI solutioin

Disclaimer: This forum provides general information and discussion about medicine, health and related subjects. The words and other content provided in this forum, and in any linked materials, are not intended and should not be construed as medical advice. If the reader or any other person has a medical concern, you should consult with an appropriate licensed Physician or other Health Care provider. Never disregard professional medical advice or delay in seeking it because of something you have read on this forum or any other linked materials. If you think you may have a medical emergency call your Doctor or 911 immediately.

The views expressed on this forum and website have no relations to any academic, hospital, practice or other institutions. This website is at times monitored. Anything the host finds offensive may be removed at his discretion. The host disclaims responsibility for anything posted by third-parties. Any statements on this forum/website related to Chlorine Dioxide, MMS or variations are not FDA approved to diagnose, cure, mitigate, treat, or prevent any disease.

MMS (Master Mineral Solution) is Sodium Chlorite 28% (22.4% Sodium Chlorite, 5.6% Inert Salts and the remainder water) plus an acidic activator (usually 50% Citric Acid or 4% Hydrochloric Acid) when combined produces Chlorine Dioxide.

License: Except where otherwise noted, content on this site is licensed under a Creative Commons Attribution-NonCommercial-NoDerivs 3.0 Unported License.