Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC:

citric acid damage to tooth enamel AND ISSUES WITH CAPTCHA 15 Sep 2019 14:45 #61350

  • Mr. E
  • Mr. E's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 1
  • Thank you received: 0
I have learned that citric acid , vinegar, lemon and lime juice, can damage tooth enamel. I have used MMS for about a decade. I have steeped up the practice of brushing my teeth with MMS, and also very recently added DMSO to the MMS per instructions. This I used with great success reversing a tooth abscess. Praise Jesus!

Recently I have had some issues with tooth enamel. Even chipping off. I want to eliminate citric acid as a possible factor.

So exactly WHAT happens to the citric acid after it activates the chlorine dioxide? Is the finished product in any way acidic? Has ANYONE else had any issues with their teeth after brushing with MMS?

Error
Please complete the CAPTCHA.

ALSO the CAPTCHA gizmo is a real PAIN. It is quite ambiguous as to exactly WHAT to click, for example with TRAFFIC LIGHTS do we click only the light? the light and light pole? And many of the images are grainy and hard to see WHAT it is! The CAPTCHA process takes LONGER than writing the post question! Many times it fails! Can be frustrating when you need help!
Please do what you can to make this easier.

Thanks much, God bless and be well!

Please Log in or Create an account to join the conversation.

citric acid damage to tooth enamel AND ISSUES WITH CAPTCHA 15 Sep 2019 17:49 #61356

  • CLO2
  • CLO2's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 5379
  • Thank you received: 4247
MMS1, CDH and CDS can be acidic. The pH of the water you use with MMS can make a big difference. Read the following forum thread and you will find my pH measurements for the teeth brushing protocol solution found in Jim's latest book. Keep in mind that the water I used was acidic.

mmsforum.io/goto/general/32324-started-mms-dmso-protocol-teeth-hurt

If you brush with an acidic solution, teeth enamel can be brushed off your teeth! Search the internet for articles on this problem.

To check the pH of your water and MMS solution, I suggest you get on inexpensive pH meter. Those paper pH test strips are not meant for use with water and can give inaccurate readings. pH meters need at least 30 seconds to stabilize and give an accurate reading. You can buy pH calibration powders to mix with distilled water to calibrate your pH meter, if needed.

I don't see Captcha when I login here. I check the box to be remembered so I don't have to login every time I visit the MMS forum.

Please Log in or Create an account to join the conversation.

Last edit: by CLO2.

citric acid damage to tooth enamel AND ISSUES WITH CAPTCHA 15 Sep 2019 21:34 #61365

  • CLO2
  • CLO2's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 5379
  • Thank you received: 4247
"Recently I have had some issues with tooth enamel. Even chipping off. I want to eliminate citric acid as a possible factor.

So exactly WHAT happens to the citric acid after it activates the chlorine dioxide? Is the finished product in any way acidic? Has ANYONE else had any issues with their teeth after brushing with MMS?"


You can find my teeth brushing protocol pH testing in this PDF file.

mmsinfo.org/infosheets/MMS1_Teeth_Brushing_Procedure_pH_Testing_Results.pdf

In Jim's latest book he says "WPS: Water Purification Solution, this is the same formula as MMS. It is 22.4% sodium chlorite (NaClO2), in purified or distilled water."

Distilled water and purified (filtered) water are usually acidic because there are no minerals in those solutions. But, some water filters don't remove all minerals from the water being filtered, such as a Berkey filter. A Zero brand water filter does remove all minerals and many other impurities such as fluoride and glyphosate. Well water I use is alkaline (7.56 pH), but when filtered with a Berkey plus a Zero water filter the alkaline well water drops to 5.7 pH, now acidic because it is below 7.0 pH.

Therefore, MMS1 (and CDS, CDH) will be acidic when distilled water and most purified (filtered) waters are used to make MMS and then added again (for dilution) when ingested.

The other problem with MMS1 is that it is about 10% activated at 30 seconds with remaining residual MMS and acid activator. CDH is about 50% activated so is less acidic than MMS1. CDS has no residual MMS or activator so is the least acidic of the three sodium chlorite solutions.

Using 50% citric acid is far too much acid to "activate" MMS as many have commented including Andreas Kalcker in his newest book. Jim now recommends using 4% HCL as the preferred MMS activator. Your stomach will like HCL much better than citric acid, too! Less nausea and diarrhea.

"pH Scale. A measure of acidity or alkalinity of water soluble substances (pH stands for 'potential of Hydrogen'). A pH value is a number from 1 to 14, with 7 as the middle (neutral) point. Values below 7 indicate acidity which increases as the number decreases, 1 being the most acidic. Values above 7 indicate alkalinity which increases as the number increases, 14 being the most alkaline. This scale, however, is not a linear scale like a centimeter or inch scale (in which two adjacent values have the same difference). It is a logarithmic scale in which two adjacent values increase or decrease by a factor of 10.

For example, a pH of 3 is ten times more acidic than a pH of 4, and 100 times more acidic than a pH of 5. Similarly, a pH of 9 is 10 times more alkaline than a pH of 8, and 100 more alkaline than a pH of 7. Invented in 1909 by the Danish biochemist S. P. Sørensen (1869-1939).

Read more: www.businessdictionary.com/definition/pH-scale.html

Please Log in or Create an account to join the conversation.

citric acid damage to tooth enamel AND ISSUES WITH CAPTCHA 16 Sep 2019 23:37 #61372

  • jmac
  • jmac's Avatar
  • Offline
  • Elite Member
  • Elite Member
  • Posts: 171
  • Thank you received: 139
Hi, CLO2

I had been using a 50% citric acid solution for a couple of years to make CDH and CDS. About a year ago I switched to 4% HCl to make CDH, but I have left-over citric acid powder that I have been using to make CDS. Is a 50% solution of citric acid too strong for that purpose? If so, what percentage would you recommend to get the most out of the sodium chlorite solution?

I'm using your double-infusion process to make the CDS, but I'd prefer a single infusion method using citric acid for simplicity.

JMAC

Please Log in or Create an account to join the conversation.

citric acid damage to tooth enamel AND ISSUES WITH CAPTCHA 17 Sep 2019 02:39 #61373

  • CLO2
  • CLO2's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 5379
  • Thank you received: 4247
Hi, JMAC.

50% CA should be fine for making CDS as long as you don't use a heating method. Of course, with 50% CA you can easily make 3000 ppm CDS using a single infusion.

I have been running more CDS tests recently and found that a single infusion using 4% HCL will get 3000 ppm CDS.

mmsinfo.org/infosheets/CDS_Made_in_a_250_ml_Capacity_Canning_Jar.pdf
Check out the updates to that PDF file.

mmsinfo.org/infosheets/CDS_3000ppm_MMS_4pc_HCL_Fridge_Single_Infusion_Testing_Sept'19.pdf
A 5th test has finished and I will be adding another page to that PDF file soon. More surprising results!
.
.
The following user(s) said Thank You: jmac

Please Log in or Create an account to join the conversation.

Last edit: by CLO2.
  • Page:
  • 1