Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC:

Making CDS 10,000 ppm or higher? 03 Oct 2018 15:47 #59190

  • jmac
  • jmac's Avatar Topic Author
  • Offline
  • Elite Member
  • Elite Member
  • Posts: 171
  • Thank you received: 139
I've seen a few references on this forum about using CDS at 10,000 ppm or higher. I make my own CDS using CLO2's double infusion method (www.mmsinfo.org) with MMS and 50% citric acid to get to around 3,000 to 3,500 ppm. I use citric acid because I have it on hand and don't want to ingest it, so it saves my 4% HCl for internal use.

In order to make 10,000 ppm or higher, would I just continue the process of replacing  the depleted MMS1 with new ingredients every 12 or more hours until I reach the desired concentration? Would I need to chill the water in order for it to absorb that much ClO2?

Please Log in or Create an account to join the conversation.

Making CDS 10,000 ppm or higher? 04 Oct 2018 01:36 #59191

  • CLO2
  • CLO2's Avatar
  • Offline
  • Administrator
  • Administrator
  • Posts: 5562
  • Thank you received: 4393
Yes, keep replacing spent MMS & activator in the reactor container over and over until you get the ppm you want. I got 10,000 without using cold water. 

By the way, increasing the amounts of MMS and activator only works to a point and then you get less! 

The following user(s) said Thank You: jmac

Please Log in or Create an account to join the conversation.

Making CDS 10,000 ppm or higher? 05 Nov 2018 13:55 #59336

  • AK
  • AK's Avatar
  • Offline
  • Senior Member
  • Senior Member
  • Posts: 40
  • Thank you received: 24
I'm not understanding how all this works.  I do know that you can buy 24,000 ppm CDS.  I do know that I've not found people who even know this nevermind how to make it.  I have been using mms for almost a year, been winging it! Been searching out the correct information if possible and trying to weed out the junk.  Difficult.  Bottom line is I"m breathing at 98 per cent 02 level and steady vs 88 and falling 11 months ago.  My doctors? resentful, intimidated and ready to find any reason why I should not be dead.  They cannot.  Blood test recently makes that point for me.  "impressive" blood test..........but I'm someone who steps outside the box and no! Not everyone loves me for that.  Ha ha!  I know I got way off subject but hey! it's 330 am.  Good luck and thank you.  I have moderate COPD and moderate Emphysema on their records. 
Margaret Kelley

Please Log in or Create an account to join the conversation.

Making CDS 10,000 ppm or higher? 05 Nov 2018 14:03 #59337

  • AK
  • AK's Avatar
  • Offline
  • Senior Member
  • Senior Member
  • Posts: 40
  • Thank you received: 24
I'm also afraid to make CDS for no other reason than I am.  Should not be that difficult, I have distilled water, the glass bottles, the instructions to leave some air holes for the gas to escape, the sodium chlorite and citric or hcl acid.  What am I waiting for?  I'm just fearful....simple.  Been thru a lot in the last year.  I've used mms until I'm too the point of I can't take it anymore.  What have I done instead? Baths!  Baths in 60 drops of mms activated.  Stops the chest pain, the same pain that my doctors say "no copd and emphysema does not hurt".  The baths stop the pain or hold them at bay at least.  The denial that pain should exist with my condition is another story.
Margaret Kelley

Please Log in or Create an account to join the conversation.

Making CDS 10,000 ppm or higher? 06 Nov 2018 01:23 #59343

  • CLO2
  • CLO2's Avatar
  • Offline
  • Administrator
  • Administrator
  • Posts: 5562
  • Thank you received: 4393
Margaret, it is not safe to make CDS using the heating method. You could have an explosion as I had one time and others did, too. 

Instead, use the simple & safe overnight method. Here is a PDF file showing the equipment needed and more. Go to page 5, part six for the recipe. 

The following user(s) said Thank You: fourfingerz

Please Log in or Create an account to join the conversation.

  • Page:
  • 1