TOPIC:

Nebulizing Chlorine Dioxide in a Water Based Solution at Increasing Parts Per Million (ppm) Increments Starting at 25ppm and Ending at 70ppm to Determine Lung Irritability of Highest Possible ppm Dose to Fight COVID-19

Since COVID-19 is a severe and deadly respiratory disease for some, and Chlorine Dioxide is known to easily deactivate all known viruses (including the coronavirus) at fairly low ppm concentrations, and since Chlorine Dioxide is also known to be non-toxic to human cells at low ppm concentrations, I decided to do a test to see how high in ppm I could get a nebulized dose of Chlorine Dioxide before there was any discomfort to my lungs. To my surprise I was able to get up to 65ppm with no discomfort at all and even at 70ppm there was only a very slight discomfort and since this high of a ppm dose far exceeds what is necessary to deactivate any virus, I decided to stop the test at 70ppm.

Based on my own personal experience with this test, accompanied with my knowledge of Chlorine Dioxide’s ability to deactivate viruses at extremely low concentrations (even as low as 0.05ppm in the gaseous state according to Taiko Pharmaceuticals, a Japanese company) I believe the SARS-CoV-2 virus can be easily deactivated within the respiratory track of patients at very safe dosages and would strongly recommend at least starting suspected COVID-19 patients on 10ppm at least every 2 hours and then if they do fine on the first dose, increase it incrementally by 10ppm each time until a maximum dose of 40 to 50 ppm is achieved if possible. For patients who have tested positive for COVID-19, I’d recommend the same as above but dose every hour instead. I sincerely believe that if this is done we will have far fewer deaths and patients will be able to go home sooner, relieving the burden on the entire hospital system, staff and country for that matter.

My Personal Chlorine Dioxide Parts Per Million Nebulizer Experiment
26 March, 2020: This was a chlorine dioxide (CLO2) nebulizer test I did where I gradually increased the amount of CLO2 being nebulized. I had been doing 25ppm for a few days but then on 25/3/2020, I decided to try 35ppm and then an hour later I did 45ppm and then decided to increase by 5ppm each hour until I ended at 70ppm.
Notes on my procedure for this experiment: I inhaled deeply for 5 seconds, held my breath for 5 seconds and then exhaled for 5 seconds. Then immediately, without taking another breath of regular air, I every time took another breath from the humidifier. So each inhale, hold and exhale took approximately 15 seconds. So 5 minutes = 300 seconds. 300 seconds divided by 15 seconds = 20 breaths per 5 minutes. Since each 5 second inhale times 20 breaths was 100 seconds of inhaling, and the humidifier being used delivered ≥ 0.58ml/minute, that means I was inhaling approximately 1.0ml of the CLO2 nebulizer solution into my lungs each 5 minute session.

pdf below

Hope that helps someone,
Scott McRae

While we're on the topic of NEBULIZING to prevent or treat respiratory diseases, I think I should mention that I've heard that 1% to 3% H2O2 (Hydrogen Peroxide), can work wonders via a nebulizer too. Dr. Rowen, Dr. Levy and Dr. Brownstein have all talked about the benefits of nebulizing with it and it's more available than CLO2. Also I've heard at least one of them say that ideally food grade should be used but in a pinch, the drugstore 3% brand, with the stabilizers inside, can also still be used. So that makes it super available, in the US anyway.

Cheers,
Scott

Hello would you please explain what you mean by ppm in terms of drops and ml or ounces perhaps. I am really confused as to what is meant by ppm. Thank you!

ppm (or parts per million) refers to the concentration within the ml or ounce. It's similar to percent. You've probably heard 2% fat in milk. 100,000 ppm clo2 would be 10% because 100,000 is 10% of 1 million.

Also 1 ppm is the same as 1mg because there are a million milligrams in a kilogram (or a liter of water)

Hope that helps a little. Concentration is essential to know when it comes to medicines because too much can harm you and too little won't do any good.

Take care,
Scott

So to measure the amount in ppm you would need a scale that measures in grams then, am I correct? Or how do you quantify the ppm for CLO2?

Dear Sir,
as I like t use MMS and I thing in drops, not in mml or gr or other, Id like to ask you: how many drops of MMS should I use to prepare a batch of MMS for the aerosol machine to be nebulizer. As you know the aerosol machine has a little container where you pour the liquids you want to nebulizer. Can you please answer my question? How many drops of MMS?
Thank you very much. If you have a site please let me know it.

Yes I would like to know that as well. For example how many actives drops per liter would be sufficient for nebulizer and how many ppm would one activates drop be per liter for example.

Go to the following link and read the 1st post which I wrote. It explains precisely how to do what you're asking with drops which activate to 3000 ppm in 5 minutes: mmsforum.io/goto/cdh/33565-quick-easy-5-minute-cdh3000

Then if you have more questions, ask away.
Scott

Can you tell me, please, if it's possible to take vitamins and supplements together with MMS? I means, can I take vitamins in the morning and the MMS cure in the afternoon?
I asked before but none answered.
Thank you