Welcome, Guest
Username: Password: Remember me
MMS: sodium chlorite (NaClO2) 28%
MMS1 or Activated MMS: chlorine dioxide (ClO2)

TOPIC: How to make HCL 4% solution (MMS activation) - Solution MUST be 4%

How to make HCL 4% solution (MMS activation) - Solution MUST be 4% 15 Jul 2019 09:57 #60872

After trying 4% HCl I can confirm the huge change using this activator over 50% citric acid, more than expected.

Not only the bad odor and aftertaste is much less noticeable but it seems to activate the sodium chlorite much more effectively.

It may be a placebo effect but with only three drops I felt a little dizzy and tired in a short time where before, with 6 or 8 drops I wouldn't feel nothing at first but after several days of treatment I felt the and increasing stomach upset sensation being increasingly more difficult to keep with the protocol without reducing the dosage.

After being more days with the protocol 1000 I will check if it is more tolerable than citric acid. Definitively MMS is the only thing I've found that is keeping a bad eczema on my arm and leg flexures at bay. I've been applying it topically for a week but with the new activator I'll start both topical and oral ingestion and see how it goes.
Cibus medicina tua et medicina cibo vestro. Let food be thy medicine and medicine be thy food. -Hippocrates
The following user(s) said Thank You: CLO2

Please Log in or Create an account to join the conversation.

How to make HCL 4% solution (MMS activation) - Solution MUST be 4% 15 Jul 2019 17:04 #60873

These charts show that 4% HCL (green curves) activates MMS faster and more fully than citric acid, externally.

The tests were for 3 drop MMS1 doses in 120 ml of water. The top chart shows the CLO2 concentration (ppm) and the bottom chart shows the amount of CLO2 in milligrams. Note that 3 drops of MMS contains 20 mg of CLO2. At 20 seconds activation time (the standard timing at the time of testing) about 10% of that 20 mg has been released from MMS. The remainder should be released in a stomach with normal amounts of gastric acids.

Also note that 60 seconds activation time seems to be the ideal activation timing. Especially if you plan on using MMS1 topically. If you use 3 ml of CDH topically, you will have about 10 mg of CLO2 available. Seven ml of CDS topically will provide 20 mg of CLO2 and may be the best Sodium Chlorite Solution (SCS) for topical use. Both MMS1 and CDH should be added to 120 ml of water for topical use, but CDS can be applied full strength. Spray bottles work well for topical use. A second spray bottle can be used to spray DMSO on top of the SCSs.

2 ml of 3000 ppm original CDS equals a 1 drop MMS1 dose in a normal stomach
www.mmsinfo.org/infosheets/mms1_equates_to_cdh_and_cds.pdf
Telegram Channel: t.me/MMSinfo
Websites: MMSinfo.org * www.facebook.com/groups/ebolacures/
Instructional Videos: www.youtube.com/channel/UCXv6hCnvjMmGg4_AYq4wlNw
Instructional Videos: www.brighteon.com/channel/clo2works
Answers to many questions are in Jim Humble's books: jhbooks.org/
How to use CDS, CDH in Protocols: www.mmsinfo.org/infosheets/CDS_CDH_and_Protocols-2.pdf
Attachments:
The following user(s) said Thank You: Vi Pacem

Please Log in or Create an account to join the conversation.

Last edit: by CLO2.

How to make HCL 4% solution (MMS activation) - Solution MUST be 4% 15 Jul 2019 18:08 #60874

So if I've understood right if I'm doing the MMS1 baby bottle and spray protocol based on your information I'd do this (please correct me if I'm wrong):

Baby bottle
  • Start with 12 drops and increase gradually until 24. Wait 20 sec. for activation and the remaining ClO2 will activate in stomach.
  • Fill with osmosis water to 350ml mark, refrigerate and take, 7 times hourly in 50ml amounts.
  • This is because the bottle has 350ml max. and mark every 50ml. so it is easier and quicker for me to divide by 7 and measure 50ml. each hour instead of eight.
Spray
  • 30 drops in 90ml. of osm. water (again, easier to round up to 90 than exactly measure 84ml). This time wait 60 sec. and mix with water and refrigerate. Spray hourly 7 times together with the baby bottle.
  • This time the ideal amount of ClO2 keeps more or less stable throughout the next days in the 90ml spray?
  • Or does it start to degrade quickly, despite being sealed and refrigerated, making you have to prepare just the right amount to consume it in one day?

Also, let me apologize for making a question out of the context of this thread but, Peter Mican mentioned this in a past post :

I have heard from a German researcher (Chemist) and MMS provider, that storing MMS in PET bottles for long term is very dangerous, after a few month the whole mixture starts smoking when activated and ingredients from the PET material are in the MMS solution.

The inactivated NaClO2 I have is stored in a bottle with an EDP logo and for the activated MMS solution I'm using a PET bottle and spray. Are these plastics safe for these uses or will they start to leach in time?
Cibus medicina tua et medicina cibo vestro. Let food be thy medicine and medicine be thy food. -Hippocrates

Please Log in or Create an account to join the conversation.

How to make HCL 4% solution (MMS activation) - Solution MUST be 4% 16 Jul 2019 06:07 #60876

Baby Bottle Question: A 12 drop MMS1 dose divided into 7 parts would equal seven 1.7 drop MMS1 doses. Activation time today is 30 seconds as per JH. You may want to add additional water to each hourly dose if it is too strong with only 50 ml of water. A 12 drop MMS1 dose, if fully activated, should provide 80 mg of CLO2 daily or seven 11.5 mg hourly doses.

If you have never taken MMS internally, or it has been some time since you last used MMS, then follow the Starting Procedure first. That protocol starts off with eight 1/4 drop hourly doses on day one.

Spray Bottle: Correct. You should be able to tell when the CLO2 in the MMS1 solution has reduced, by the yellow color fading. Keeping it in a fridge should help.

Glass Bottles are usually the first choice for containers when storing chemicals. PET and HDPE bottles have been used for years by sellers of MMS products. Leaching of plastics into solutions could be a problem. You can look online for compatibility of those plastics with the chemicals in question. I have had MMS stored in HDPE bottles which cracked and leaked. Recently I picked up a new, unused HDPE plastic bottle and when gently squeezed, it cracked! No idea why that happened. When I make MMS, I store it in glass bottles.
2 ml of 3000 ppm original CDS equals a 1 drop MMS1 dose in a normal stomach
www.mmsinfo.org/infosheets/mms1_equates_to_cdh_and_cds.pdf
Telegram Channel: t.me/MMSinfo
Websites: MMSinfo.org * www.facebook.com/groups/ebolacures/
Instructional Videos: www.youtube.com/channel/UCXv6hCnvjMmGg4_AYq4wlNw
Instructional Videos: www.brighteon.com/channel/clo2works
Answers to many questions are in Jim Humble's books: jhbooks.org/
How to use CDS, CDH in Protocols: www.mmsinfo.org/infosheets/CDS_CDH_and_Protocols-2.pdf
The following user(s) said Thank You: Vi Pacem

Please Log in or Create an account to join the conversation.