HIV: How Much IV CLO2 It Takes To Cure HIV (and possibly Ebola, Zika, Dengue, etc.)

Scott said, "I don't know where you got it that 1ml of CDH is 1000ppm but it's wrong, if the original procedure is followed you'll end up with just about 3500ppm in a ml or 3.5mg per ml."

Please read my comments here for more info on dosing using milligrams of CLO2.

Note that Scott's CDH dosage of 3.5 mg per milliliter can be found in the last chart (non-ingested chart) here.

I use info from instruction:
CDH: How to Make and use 100ml of 3500 ppm & 100 ppm CDH
92ml distilled water
4ml 22.4% sodium chlorite water solution
4ml 4% Hydrochloric Acid (HCI)

CDS, CDH and Protocols / Using CDS and CDH with Protocols
MMS1 3 drops CDH 3ml CLO2 20.1

CDH that I want to use to inject IV, do I must first sterilize or filter it.

Protocol 1000
3 drops every hour a day 8 times = 24drops, 24,000ppm CLO2 mg = 160.8
How much of this amount enters the blood?

Now if inject IV why very low dosage is applied.
Comment welcome

Lopez2017,
You asked why such a low dosage is needed with injection (compared to oral ingestion I think?). For me the reason is 2-fold:

-First, as we can see, according to this patent, not very much is needed. However I and others here in Indonesia have injected 10ml of 100ppm 3 to 4 times a day with good success in curing disease and no known negative side effects. So that would be just 40ml of 100ppm in a day which would be 4000ppm or 4.0mg in a day (still not even the 6.7mg found in just 1 drop of MMS1)
-Secondly, for me anyway, it's out of an abundance of caution since we are sailing in uncharted waters.

For very contaminated water they only use a maximum of 2ppm to make it safe - this kind of tells us how potent CLO2 is. We don't really need that much.

In the case of injection though, we should think about the fact that 1 injection of 10ml of 100ppm is actually going into about 5 liters of blood. So if we use these amounts in a dilution calculator we find that 10ml of 100ppm diluted into 5 liters of blood will give us 5,010ml of just 0.20ppm. Seems pretty darn safe to me.

However you do it please let us know how it goes and what you're using it for because we would really like to know.

Hope this helps,
Scott

Truthquester wrote: Lopez2017,
However you do it please let us know how it goes and what you're using it for because we would really like to know.

In a few weeks I have then Syringes / needles / infusion sets everything complete and I start with injecting for few days, blood test before injection and after the injection we will see if the infection is gone.
Dosage amount in ml and strength must be calculated correctly.

Sounds great Lopez2017,
Looking forward to hearing your success story

All the best,
Scott

Truthquester wrote: Sounds great Lopez2017,
Looking forward to hearing your success story

All the best,
Scott

Scott,
If you can send your whatsapp nr to my email address, we can exchange information quickly.
Before I start with injections, everything check double for verification confirmation dosage ml, needle syringe where to inject etc...
Small wrong calculation can be fatal, fault with injecting air into the bloodstream can be deadly.
I took a special holiday to do this experiment.

Hi Lopez2017,
It doesn't look like we have the ability to send private messages to each other on this forum anymore for some reason so I can't give you my contact info that way. Open the attached pdf below which I just put in the last thread I created here on the forum, and you'll find everything you need to contact me. I will help you in any way I can. By the way, I do use Whatsapp too.

This has also been posted to my Facebook group: The Ebola Cures
www.facebook.com/groups/ebolacures//


(If you can't open the above pdf, try clicking on the "Attachments" link below in the lower left corner of this post - that's what I have to do with Firefox)

All the best,
Scott