TOOTH INFECTION

DDS prescribed Clindamycin 300mg for my abscessed, loose molar until he extracts it next week. What dose of MMS could be equivalent or better to the Clindamycin 300mg. I am afraid of the side effects of this drug. I don't have jims book yet.
thanks

Clindamycin is an antibiotic useful for the treatment of a number of bacterial infections. (Wikipedia)

Chlorine Dioxide (CLO2) is effective against bacteria. MMS1, CDH and CDS are Sodium Chlorite Solutions (SCS) that contain CLO2. Direct application of SCS to your tooth is possible because you have easy access to the tooth. DMSO is a carrier and can carry whatever is mixed with it into tissue and even bone. The SCS with the highest CLO2 content when used externally would be CDS (100%), followed by CDH (50%) and last, MMS1 (10%).

If you have or can make CDS, it should be the best SCS to use along with DMSO mixed with it. The amount of a SCS mixed with distilled water (if you have it) would be 1 part SCS to 4 parts water. DMSO can be added to the SCS + water solution after you have rinsed your mouth with the SCS + water only solution to remove anything you don't want DMSO to carry into your mouth tissue and tooth.

Start with 1 drop of DMSO added to the SCS + water solution and increase by 1 drop each application. Hold this SCS + DMSO solution in your mouth as close to the problem tooth as possible for 1 minute or longer, then spit it out. You can do this protocol hourly.

Hi,
I would appreciate some advice.
Finding it difficult to understand the chemicals mentioned above fully.
I have been using MMS, HCLA   and DMSO  for 10 days for a tooth abcess and fistula.
It doesn't seem to be working though.
I started with a much weaker solution i.e. with more water added than i am using now.
I am currently mixing 5 drops sodium chlorite solution - 28% (22.4% Effective ),
 with 5 drops HCL solution (HCL 4% )
 with 15 drops DMSO,
 with 20 mililitres of bottled water.
Every 2 hours, I am holding it in my mouth over the abscess/fistula area for 2 minutes, sometimes 3.
It is really stinging my tongue & the inside of my lips which are feeling kind of permanently sore.
Could the lack of improvement be because I am taking quite a lot of supplements at the moment, even though I'm  only it using the  solution in my mouth and not taking any.
Thank you very much for any advice.

DMSO must  be added to each dose and not to a solution that you might keep for hours. DMSO will eventually kill CLO2.

MMS1 activated for 30 seconds does not release much CLO2 from MMS; only about 10% of what is possible. If you want more CLO2 for your teeth problems, try making CDH which will have about 50% of the available CLO2 externally (not in stomach acid). 

A neighbor has been keeping his teeth problems mostly under control using CDH or CDS. On occasion he does use an antibiotic. He's been doing this for years. He can't afford to see a dentist. 

Thank you CL02
Great to get advice.I was making my doses up freshly each time just before adding the DMSO and using.Will make some CDH and try that instead now though.

Thank you CLO2
I've only just made some CDH solution up for the first time.Before that I was trying something different,  but it hasn't worked.Could you recommend how often I should use it and for how many minutes and how many days please?
Should I add any DMSO?I'm planning on brushing my teeth with it, concentrating  mainly on the abcess tooth and area.Many thanks.

Hi sunnyday,

Whatever you do it's important to keep the CLO2 concentration from being too high.
How high is too high?
I don't know for sure but I do know that 3500 ppm which is what your CDH is right when you make it, is too high.
How do I know that?
Because I had a tooth ache and put it on my tooth at that 3500 ppm concentration on and off for a few days trying to kill the infection, and it ate away my enamel on all those teeth on that lower side of my mouth, right along the gum line where it basically puddled and sat.
Now if you're adding any water to it at all it's going to be lower than 3500 ppm but like I said, I don't know what the safe ppm is.

Another mistake I made was thinking that there was even an infection to kill. Actually there wasn't an infection but because of a previous cavity, I had an exposed root and that was what was causing my pain. So I screwed my teeth up needlessly.
Did I stop using CDH?
No. I still brush my teeth with it twice a day but I keep it at 50 ppm.

So please be careful.

CLO2 might have a good idea what concentration is safe since his neighbor has used it for so long.

Good luck,
Scott McRae

Thank you very much Scott.
Let me think about it all and get back to you.
sunnyday

No problem - let me know if you have any questions. Remember though, don't use CDH full strength on teeth.

Hi Scott,

Thank you very much for your replies and for telling me some things which  can go wrong.
It takes me a while to reply as I have M.E.
I mixed mine up in this concentration :-
(From mmsinfo.org/infosheets/infosheet_cdh.pdf )

22 parts water + 1 part SC + 1 part acid       (22+1+1=24)
I used
55ml distilled water
2.5 ml HCL 4%
2.5 ml Sodium Chlorite 28% (22.4% effective)
Do you think that should be alright?
I'm only using it once  a day for now, to be cautious.
(Mine is definitely a tooth abcess,  been diagnosed by my dentist, and has a fistula.)

Many thanks,
sunnyday.