TOPIC:

CLO2, thank you so much.l have MMS and 50% citric asit. l am waiting for your help. Good nights.

Hi everyone on this thread/topic. I just got off a call with CLO2 where we talked about our differing thoughts and discovered why we are coming up with what appear to be different expectations of putting concentrated CLO2 on the skin.

CLO2 either sprays the skin with the CDS (CDS doesn't have any sodium chlorite in it like CDH does) or applies the CDS with a cotton bud followed by DMSO in another cotton bud. This approach doesn't trap the CLO2 at the site and allows it to evaporate or gas out into the air fairly quickly and doesn't cause any kind of a burn on the skin but he did say the DMSO can cause some irritation.

I use CLO2's approach (minus the DMSO) for general purpose skin sanitization, cuts, scrapes and wounds.

My approach for skin cancer, moles, warts and other hard to remove stuff on the body's exterior has been to use full strength 3500ppm CDH (without DMSO) and trap the CLO2 at the site by saturating a small amount of tissue and then covering it and holding it in place using plastic packaging tape which doesn't allow the CLO2 gas to escape to the air. This method of mine does cause a chemical type of burn on the skin and is actually one of the goals of doing it this way. For example with a skin cancer and this method, the goal for me has been to use the CLO2 to penetrate and burn the cancer cells so that the cancer (or mole, or wart) is chemically burned and then it just falls off. So far it has always worked after 1 or sometimes multiple applications.

So we have been talking about 2 different ways of applying CLO2 to the skin and I think both have their purposes.

In the case of the 5 cm cancer tumor that Lori is talking about treating, which is below the skin, I personally think CLO2's approach might work but I wouldn't rely on it myself because 5 cm is a pretty big tumor and so I would want to hit it much harder and faster so as to not give it a chance to grow any larger. I would do that by injecting directly into the tumor as described in the patent, using approximately 200 ppm CDH.

In case you don't know how to make CDH Lori, here's a video that CLO2 made on how to make it:


And then you would also need to dilute it so here's a link to a real good dilution calculator (use the last one on the page):
www.endmemo.com/bio/dilution.php

Hope this helps. Let us know if you need any other assistance.

All the best,
Scott

Scot, thank you so much. l also believe injection can be the best way. but l afraid if l make a mistake and l also dont know what will l add into the 200ppm CDH before inject it.
l wish l was a doctor. ls there anyone understand this in Turkey? Maybe he/she can help us.

Lori, I posted the following in another forum thread that would be helpful for you, too.

My website is mmsinfo.org/ You will find written articles on making CDS and a link to my YouTube channel where you will find a video showing my double infusion method of making 3000 ppm CDS. Recently, I have come up with a way to make 3000 ppm CDS using MMS and 4% HCL with only a single infusion. Here is the link to that paper. mmsinfo.org/infosheets/CDS_3000ppm_MMS_4pc_HCL_Fridge_Single_Infusion_Testing_Sept'19.pdf

To make CDS stronger than 3000 ppm CLO2 concentration, you can repeatedly discard spent reactor solutions and add fresh ingredients until you get the desired stronger CDS. Each infusion should add about 2000+ ppm at 12 hours. Activating for longer periods of time should add even more CLO2 into the same CDS in the receiver container.

lori1 wrote:

Scot, thank you so much. l also believe injection can be the best way. but l afraid if l make a mistake and l also dont know what will l add into the 200ppm CDH before inject it.
l wish l was a doctor. ls there anyone understand this in Turkey? Maybe he/she can help us.

I know what you mean Lori, I wish I was a doctor too. Regarding what to add to the 200ppm CDH, I wouldn't add anything - according to the patent, nothing is added as far as I can tell. So I would just need to make the CDH following the instructions found here in the forum, dilute it down to 200ppm using distilled water and then using a syringe, inject directly into the tumor a number of times at various locations in the tumor to basically spread the CDH throughout it. I would also also numb the area first using an ice cube or if available, some sort of numbing medication like dentists use.
I would do this once and then wait 2 or 3 days before doing it again, giving my body a chance to eliminate the dead cells and detox. Then I'd wait and do it again and again and again until the mass was gone.

Hope that helps a little bit.

May you and your friend be well,
Scott McRae

Scot, Thanks again. You are so kind. l wish you were here in Turkey and do this injection together. Why you are so away from us
l really afraid if l damage her. l dont know any doctor or nurse here to help us. But l believe this injection can kill the tumor. Maybe within 3 months, maybe within 6 months.
We are so closed to bulgaria. ls there anyone who can hep us in the Bulgaria care center ?

Lori, unfortunately the Bulgarian care center is closed.

You are following Protocol 3000 now. You should also be following Protocol 2000.

You could also try the MMS1/DMSO Patch Protocol instead of Protocol 3000. That protocol starts on page 135 in Jim's latest book. It is more intense than Protocol 3000. Personally, I would use CDS or CDH instead of MMS1, but you could try all three sodium chlorite solutions (SCS). I suggest to not use DMSO at first and see how high you can go in dosing without causing too much skin irritation. Then add a small amount of DMSO and keep increasing the amount of DMSO.

To quote from the book, "While Protocol 3000 is one way to absorb chlorine dioxide into the body, through the skin, the patch is designed to target a specific area of the skin." And another quote from the book, It is best to hold the patch in place (with your hand/fingers) as putting tape on the soaked gauze pad could have a reaction with the DMSO. If you use CDH or CDS, just soak the patch (without the liquid running out) and apply.

CLO2, thanks. we will start protocol 2000 and MMS1/DMSO Patch Protocol too. l also will try to produce 24000 PPM CDS soon.
But please tell us if you hear or meet a person in Turkey who can help us for injection.

Great News!

For those of you who have read this far, here is a link to another post here on the forum where approximately 200ppm CDH is being used to treat breast cancer using the methods basically described in this patent, and it's working. After just 6 days of treatment, there had been at least a 30% reduction in the size of a 5 to 6 cm tumor: mmsforum.io/goto/cdh-research/30833-cdh-intravenous-injection-of-dilute-cdh-to-cure-infections-of-the-blood-appears-to-be-safe-and-very-effective?start=36

All the best,
Scott McRae